Merlin Powerlift Guide d'installation télécharger pdf (Page 31)

rapid resume logic

The Rapid Resume Logic feature ensures that when the security system is powered

back up after being disconnected, the system will resume the same state it was in

before power was lost. For example, if power is disconnected during a full trigger

sequence, the system will still be in the full trigger sequence when power is reconnect-

ed to the unit. If power is disconnected while the unit is disarmed, it will still be dis-

armed when power is restored.

remote control sensor disable

1. Arm the system.

2. Use the transmitter to bypass the sensor by pressing the and but-

tons at the same time.

3. The lights will flash four times. All Warn Away

zones are now bypassed.

4. Transmit the sensor bypass channel again.

5. The lights will flash four times again. The sensor Warn Away

and full trigger

zones are now bypassed. To bypass the tilt sensor press the sensor disable but-

tons twice.

6. The sensor zones will reset when disarmed.

NNOOTTEE::

Sensor disable can be performed at any time after the alarm has been armed.

adjusting the tilt sensor

Select either a high sensitivity threshold for extreme sensitivity, or a low sensitivity

threshold can be selected for normal sensitivity.

auto-immobilization feature

Immobilizer circuits automatically activate after 30-seconds.

NNOOTTEE::

H4 orange ground when armed will not activate during Auto-Immobilization

auto-immobilization sequence

1. Turn ignition off or disarm alarm.

2. After 30-seconds the systems Immobilization circuits activate and engage the

starter and engine interrupts.

3. LED flashes at ½ normal speed.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Merlin Powerlift Guide d'installation Page 31