Merlin Powerlift Guide d'installation télécharger pdf (Page 24)

chirps - off/loud/quiet

Off: Chirps will not sound when arming/disarming the system (with the excep-

tion of arm/disarm diagnostic chirps and programming chirps).

Loud: Chirps will sound when arming/disarming the system at full volume.

Quiet: Chirps will sound when arming/disarming the system but at a lower

volume than normal.

panic - on/off

Allows the remote to activate Panic Mode. The siren will sound for 30 seconds.

On: The system will enter Panic Mode if the arm/disarm button is pressed for

more than 2 seconds.

Off: Panic Mode is disabled.

siren duration - 30/60/90

The system will sound the alarm for the programmed duration (30/60/90 sec-

onds) during an alarm trigger or when the system is put into panic mode.

user selectable features descriptions - column two

change valet/pin code

This feature allows you to change the user's personal PIN code. For more infor-

mation, see programming note #3.

select siren sounds

This feature allows you to select which siren sounds will be played back when the

alarm is triggered. Use the following procedure to set this feature:

1. Enter the feature.

2. Press the button of the remote to begin the playing of siren sounds.

3. Siren will generate each sound for 5-seconds.

4. To add the sound press the button on the Valet switch while that sound is

playing.

5. To delete the sound press the button on the Valet switch while that sound is

playing.

NNOOTTEE::

After selecting or deleting a sound the siren will immediately play the next

sound. If no sounds are selected by pressing the or button the system will

remain in its previous setting.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 36 37

Pas de commentaire

Merlin Powerlift Guide d'installation Page 24