Merlin Powerlift Guide d'installation télécharger pdf (Page 16)

remote start shunt input when ground is applied during remote start and aux output

is programmed to remote start.

h1 and h24 grey twin bonded harness

Connect to the blue and black wires of the long lever protection switch. It will report

on zone 4.

optional sensor harness, MUX wires

red and black wires

These wires supply constant 12 volts and ground to the sensor.

blue and green wires, zone 2 zone 3

These wires are multiplex inputs. If a (-) input of less than 0.8 seconds is supplied to

either wire, the Warn Away

response will occur. This is indicated by 5 rapid chirps

from the siren. A (-) input of longer than 0.8 seconds to either wire will initiate the

triggered sequence and report Zone 2 or Zone 3.

in-key 2-button transmitter—key blade installation

The exploded view below shows the assembly of the in-key 2-button transmitter. The

owner must provide a spare ignition key to be used. Use the following procedure:

1. Measure the length of the key blade from the end of the key to the original plas-

tic key housing. Add 9/32–inches to this measurement. That is how long the key

blade needs to be when cut as 9/32–inches of the blade will be inside the In-

key transmitter when the modification is completed. Make sure the cut is straight

and free from burrs. Use a grinder or file if required.

NNOOTTEE::

Do not cut the key where the end of the blade meets the plastic or the key may

not be long enough to operate the ignition switch after modification.

BLUE WIRE

ZONE 2

GREEN WIRE

ZONE 3

BLUE WIRE FROM PLUG-IN

504C SHOCK SENSOR

BLUE AND GREEN WIRES FROM

508D DUAL ZONE PROX SENSOR

GREEN WIRE FROM

PLUG-IN SHOCK SENSOR

CUT

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

Pas de commentaire

Merlin Powerlift Guide d'installation Page 16