Merlin Powerlift Guide d'installation télécharger pdf (Page 10)

valet switch

1. The Valet/program switch needs to be placed in a position where the customer

has easy access for programming and override but where it will not get wet.

Examples are under the seat or inside a compartment the owner can get to.

Discuss placement of the switch with the vehicle owner and avoid placing the

switch where it can be pressed accidentally.

2. If necessary check for rear clearance and then drill a 9/32–inch hole for mount-

ing the switch.

3. Clean and dry the surface area where the switch is to be mounted.

4. Mount the switch using the supplied adhesive tape.

5. Mate the switch’s BLACK connector to the BLACK connector with the GREY and

BLACK wires from the control unit.

GREY/BLAC

WIRE

HARNESS

CONNECTOR

VALET

SWITCH

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 36 37

Pas de commentaire

Merlin Powerlift Guide d'installation Page 10