Merlin MJ3800R Instructions d'exploitation télécharger pdf (Page 5)

urvey the area to see if any of the conditions below apply to your installation. Additional materials may be required. You

may find it helpful to refer back to this page as you proceed with the installation of your opener. Depending on your

requirements, there are several installation steps which may call for materials or hardware not included in the carton.

This opener is compatible with:

•

One piece spring balanced roller doors able to hold still at all positions of the door

• Doors up to 6.0m high

• Doors up to 5.5m (18’) wide

• Doors up to 25m

• Door axle diameter must not exceed 35mm

Considerations:

• Review or inspect proposed installation area. Opener can be installed on left or right side of door. Select the side that

meets the requirements listed below.

• Must have a drum wheel comprising three mounting holes corresponding to the base plate provided (suits most brands

of commercial roller door).

• An electric outlet is required within 1.8m (6’) of the installation area. If outlet does not exist, contact a qualified electrician.

• Depending upon the construction, extension brackets may be needed to install safety reversing sensors.

• Any gap between the floor and the bottom of the door must not exceed 6mm, otherwise the safety reversal system may

not work properly.

ASSEMBLY STEP 1

Before installing the unit, attach the mounting brackets correctly to the unit using the provided screws (figure 1). Once

attached the unit is ready to be wall mounted (figure 2).

Figure 1

Figure 2

DOOR REQUIREMENTS

1 2 3 4 5 6 7 8 9 10 ... 23 24

Pas de commentaire

Merlin MJ3800R Instructions d'exploitation Page 5