Merlin MJ3800R Instructions d'exploitation télécharger pdf (Page 13)

pener

Quick-Connect Terminals

WHT/BLK

WHT

Sensor

Connections

To Power

Door Lock

To Multi-function

Control Panel

Connect Wire to

Quick-Connect

Te rminals

red

white

WIRING THE SAFETY REVERSING SENSORS TROUBLESHOOTING THE SAFETY

REVERSING SENSORS

1. If the sending eye indicator LEDs are both flashing

after installation, check for:

• Electric power to the opener.

• A short in the white or white/black wires. These can

ccur at staples, or at opener connections.

• Incorrect wiring between safety reversing sensors and

opener.

• A broken wire.

2. If the sending eye indicator light glows steadily but the

receiving eye indicator light doesn't:

• Check alignment.

• Check for an open wire to the receiving eye.

3. If the receiving eye indicator light is dim, realign

either sensor.

NOTE: When the invisible beam path is obstructed or

misaligned while the door is closing, the door will

reverse. If the door is already open, it will not close

and the LED indicator light will flash 10 times. See

page 21.

USING THE MULTI-FUNCTION DOOR

CONTROL

THE MULTI-FUNCTION DOOR CONTROL

Press the actuator

button to open or

close the door.

Press again to

reverse the door

during the closing

cycle or to stop the

door while it's

opening.

Light feature

The Light function is not available with the MJ3800R.

Lock feature

Designed to prevent operation of the door from

hand-held transmitters whilst still allowing the door to open

and close from the Door Control, the Outdoor Key Switch

and the Keyless Entry Accessories. To activate, press and

hold the Lock button for 2 seconds.

To turn off, press and hold the Lock button again for

2 seconds. The Lock feature will also turn off whenever the

“learn” button on the opener panel is activated.

Note: This feature does not operate the Powered door

lock.

Actuator

Button

LED Indicator

light

LIGHT

LOCK

• Run the wires from

both safety

reversing sensors to

the opener. Use

nsulated staples to

secure wire to wall

and ceiling.

• Strip 11mm (7/16")

of insulation from

each set of wires.

Separate white and

white/black wires

sufficiently to

connect to the

opener quick-

connect terminals:

white to white and

white/black to grey

(shown right).

AUTOMATIC CLOSE TIMER FUNCTION

Note: Requires the Chamberlain Protector System

(IR-sensors) to be installed. If the Protector System

(IR-sensors) is installed only to enable the timer to close

function (first time), install sensors, close the garage door

and wait for 5 minutes.

A Multi-function Door Control is required to enable and

disable the auto-close function.

Enable: Push and hold lock button on the Multi-function

Door Control until the electric lock toggles twice. Release

the lock button, at the same time watch the LED light in

the center of the actuator button from the Multi-function

Door Control.

1x flash 10 seconds Auto-Close

2x flash 45 seconds Auto-Close

3x flash 2 minutes Auto-Close

4x flash 3 minutes Auto-Close

5x flash OFF Auto-Close

Factory setting is OFF. Repeat the procedure until the

Multi-function Door Control shows the required number of

flashes.

Door may operate unexpectedly, therefore do not

allow anything to stay in the path of the door.

Auto close is NOT recommended for households with

young children.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Merlin MJ3800R Instructions d'exploitation Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Merlin MJ3800R