Merlin MJ3800R Instructions d'exploitation Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
4
BEFORE YOU BEGIN:
Disable locks.
Remove any ropes connected to door.
Complete the following test to make sure your door is
balanced and is not sticking or binding:
1. Lift the door about halfway as shown. Release the door.
If balanced, it should stay in place, supported entirely
by its springs. Repeat this test in a number of different
positions to ensure the door is correctly balanced.
NOTE: The spring should hold the door at any open
position without creeping up or down.
2. Raise and lower the door to see if there is any binding
or sticking.
IF YOUR DOOR BINDS, STICKS OR IS OUT OF BALANCE, CALL A
TRAINED DOOR SYSTEMS TECHNICIAN
.
3. The installer is to ensure that the temperature range is
suitable for the installation.
To prevent damage to door and opener:
• ALWAYS disable locks BEFORE installing and operating the
opener.
T
o prevent possible SERIOUS INJURY or DEATH:
• ALWAYS call a trained door systems technician if door
binds, sticks or is out of balance. An unbalanced door may
not reverse when required.
• NEVER try to loosen, move or adjust door, door springs,
cables, pulleys, brackets or their hardware, ALL of which are
under EXTREME tension.
• Disable ALL locks and remove manual opening chain if
attached to the door BEFORE installing and operating the
door opener to avoid entanglement.
• This device is not intended for use by small children
or infirmed persons without supervision.
• young children should NOT be permitted to play
with the opener or transmitters.
TOOLS NEEDED
During assembly, installation and adjustment of the opener, instructions will call for hand tools as illustrated below.
Pliers
Wire Cutters
Claw Hammer
Screwdriver
Adjustable End Wrench
Sockets and Wrench
with extension
Drill
Tape Measure
2
1
Stepladder
Pencil
Hex Key Wrench
Needle Nose Pliers
Drill Bits
Torque Meter (not shown)
SPECIFICATIONS
Volts: 230-240 ~ V 50 Hz
Power: 145 Watts
Rated Load: 63Nm @ drum
Fmax: 253Nm @ drum
Max door height: 6.0m
Max door width: 5.5m
Max area: 25m
2
Temperature range: -20˚ C to 55˚ C
Please note this opener contains both imperial and metric fasteners.
PREPARING YOUR DOOR
Vue de la page 3
1 2 3 4 5 6 7 8 9 ... 23 24

Commentaires sur ces manuels

Pas de commentaire